Data as of: 2026-08-05 Administration DE EN
Plant Protection Product Search

« Products

SUNDA

Authorisation number: 00A756-00

Formulation
Emulsion, oil in water
first authorised
2021-05-17
authorised until
2027-11-30
Field of activity
Herbicide
Hazard to bees
no classification recorded
Trial designation
12463-40002-H-0-EW

Active substances

Active substanceEnglish name ContentCategoryEU approved
Fenoxaprop-P fenoxaprop-P 69 GL Wirkstoff yes
Mefenpyr mefenpyr 19 GL Safener

Holder and distribution

Authorisation holder
SHP

Authorised uses (3)

CropPest Area of useUse no.
winter soft wheat, winter triticale, winter rye spring oat, windgrass, annual bluegrass Outdoors 00A756-00/00-001
winter barley spring oat Outdoors 00A756-00/00-002
spring soft wheat, spring barley spring oat Outdoors 00A756-00/00-003

Conditions of use

Code Text Crop Buffer zone
NW470 Where applicable, fluids left over from application, granules and their remains as well as cleansing and rinsing fluids must not be dumped in water. This also applies to indirect entry via the urban or agrarian drainage system and to rain-water and sewage canals.
SF275-VEAC For the period after application until shortly before harvest in field crops, it must be ensured that long-sleeved working clothes and sturdy footwear are worn during successive work/inspections with direct contact with the treated crops/areas.
SS110-1 Protective gloves (plant protection) must be worn when handling the undiluted product.
SS2101 Wear a protective suit against pesticides and sturdy shoes (e.g. rubber boots) when handling the undiluted product.
VA271 When applying the product, a minimum buffer zone of 5 m must be kept to adjacent areas which are used by uninvolved third persons. Alternatively, driftreducing equipment which is registered in the index of 'Loss Reducing Equipment' of 14 October 1993 ("Bundesanzeiger" (Federal Gazette) No 205, p. 9780) as amended, and registered in at least drift-reducing class 50 % can be used for application. In this case, the minimum buffer zone for field crops stated in the BVL publication in the Federal Gaz

Restrictions

Code Text Crop Buffer zone
WMH1 Mode of Action Group (HRAC/WSSA-Code): 1
SS206 Working clothes (if no specific protective suit is required) and sturdy footwear (e.g. rubber boots) must be worn when applying/handling plant protection products.
SF245-02 It must be ensured that treated areas/crops may not be entered until the film of the plant protection product has dried.
SB166 Do not eat, drink or smoke when using this product.
SB111 Concerning the requirements for personal protective gear for handling the plant protection product the material safety data sheet and the instructions for use of the plant protection product as well as the guideline "Personal protective gear for handling plant protection prod-ucts" of the Federal Office of Consumer Protection and Food Safety (www.bvl.bund.de) must be observed.
SB010 Keep out of children's reach.
SB005 If medical advice is needed, have product container or label at hand.
SB001 Avoid any unnecessary contact with the product. Misuse can lead to health damage.
NW642-1 The product may not be applied in or in the immediate vicinity of surface or coastal waters. Irrespective of this, the minimum buffer zone from surface waters stipulated by state law must be observed. Violations may be punished by fines of up to 50 000 EUR.
NW264 The product is toxic for fish and aquatic invertebrates.
NW262 The product is toxic for algae.
NN2002 The product is classified as slightly harmful for populations of relevant beneficial predatory mites and spiders.
NN2001 The product is classified as slightly harmful for populations of relevant beneficial insects.
EB001-2 SP 1: Do not contaminate water with the product or its container (Do not clean application equipment near surface water./Avoid contamination via drains from farmyards and roads).
WH952 The indication identifying the mode of action must be assigned directly to each corresponding name of the active substance as supplementary information on the packaging and in the instructions for use.
WH951 The risk of resistance has to be indicated on the package and in the instructions for use. Particularly measures for an appropriate risk management have to be declared.

Notes

Hazard classification (GHS/CLP)

Hazard pictograms

Hazard statements

Precautionary statements

Pack sizes

Further information

Data source: PSM-API · Data as of: 2026-08-05

Only the authorisation notice together with the product label and instructions for use is legally binding.