| DH001 |
RSh 1: Toxic in contact with the eyes. |
– |
– |
| EO001 |
SPo1: After contact with skin, first remove product with dry cloth and then wash with plenty of water. |
– |
– |
| EO002 |
SPo2: Wash all protective cloth after use. |
– |
– |
| EO004 |
SPo 4: The container must be opend outdoors and in dry conditions. |
– |
– |
| NW262 |
The product is toxic for algae. |
– |
– |
| NW264 |
The product is toxic for fish and aquatic invertebrates. |
– |
– |
| SB001 |
Avoid any unnecessary contact with the product. Misuse can lead to health damage. |
– |
– |
| SF5053 |
Phosphane develops in the air or in combination with moisture; it is an odourless gas which is very toxic for humans and animals, it is corrosive and is both highly flammable and self-igniting when exposed to air. Occasionally there is a garlic-, fish- or carbide-like smell caused by impurities. This smell alone is not a reliable indication of phosphane since it can easily be adsorbed by soil and other materials and is often not apparent until health limits have been exceeded. |
– |
– |
| SB110 |
The directive concerning requirements for personal protective gear in plant protection, "Personal protective gear for handling plant protection products" of the Federal Office of Consumer Protection and Food Safety must be observed. |
– |
– |
| SB195 |
Suitable equipment and resources must be used for applying the preparation. Contact with the skin must be avoided. |
– |
– |
| SE1201 |
Wear tight fitting eye protection when applying/handling the product. |
– |
– |
| SF510 |
If an applicator is used to apply the plant protection product, this must be cleaned according to point 9 par. (5) of 'TRGS' 512 (technical regulations for dangerous substances) after use. The equipment must be cleaned in the open and preferably when there is a light wind (paying attention to the wind direction), taking care to avoid exposing humans and animals to dust from the plant protection product and/or phosphane. The applicator should be cleaned in a sufficiently large container with low |
– |
– |
| SS2204 |
Wear a protective suit for plant protection products and sturdy shoes (e.g. rubber boots) when applying/handling the product. |
– |
– |
| SF514-1 |
The operator or person equipped with adequate experience responsible for measuring the fumigation product used must check the ambient air regularly in accordance with 'TRGS' (technical regulation for dangerous substances) 512 (fumigations) until the area has been authorised for access to ensure that concentrations of the fumigation product which exceed the limit of detection (more than or equal to 0.01 ppm) do not occur outside of the specified danger zone. The measurement results and, if approp |
– |
– |
| SF524 |
Rooms/stores must be vacated and closed immediately after fumigation has been started. For use under gas-tight sheeting, put the goods in gas-tight packaging and vacate the danger zone immediately after fumigation has started. |
– |
– |
| SS1201 |
Wear standard protective gloves (plant protection) when handling/applying the product. |
– |
– |
| ST3312 |
Wear respiratory equipment with filter (type/identification colour ...*)) for phosphane when applying/handling the product and suitable protective clothing according to TRGS 512.
*) state respiratory equipment, gas filter type (identification letter and colour) and gas filter class. |
– |
– |
| VS005-1 |
Fumigations with substances stated in "GefStoffV" (Hazardous Substances Ordinance) annex I no.4.1 (1) till (3) require permission according to GefStoffV annex I no. 4.2 (1). When applying the product, the special regulations in GefStoffV annex I no. 4 in addition to the technical regulations for hazardous substances (TRGS 512 - Fumigations) must be observed. |
– |
– |
| WMI24A |
Mode of Action (IRAC-Group): 24A |
– |
– |
